X Fusion Spacing Shock Bush's CNC Alloy 7075 From £2.50

Brand : X-Fusion

These are the Top Hat shaped CNC 7075 Alloy bushes found in pairs at both ends of every shock.
X-Fusion have produced shocks now for over 10 years and are fitted by most major manufacturers.
Easy to replace and available in a large range of sizes.
Sold as a single bush so you require two for each end of the shock (ie. 4 per shock)
Size is based on the flange thickness in mm.
To work out size required, measure across the flats of the bushes in place, Take away 14 mm and halve the remainder.
This will give you the flange width of one bush. Available in 1mm increments from 1mm to 18mm.
Remember there are two hole diameters, 8mm and 6mm so check before specifying.
It is recommended when fitting new Top Hat bushes that you also fit new DU Bush.

EXAMPLE: YOUR BUSHES MEASURE 36mm ACROSS THE FLATS.

TAKE AWAY 14mm. LEAVING 22 mm. HALF THE REMAINDER = 11mm.

THEREFORE BUSH REQUIRED IS 11mm.